Filter
Top Products
15
PAGING
To page the person who has the hand-
set or to locate the handset when the
phone is not in use, press
PAGE
on the
base. The handset beeps for about 15
seconds. To stop the beeping sooner,
press
TALK
on the handset twice or
PAGE
on the base.
Notes:
• Make sure you press
TALK
twice to
stop the handset from beeping. If
you press
TALK
only once, you get a
dial tone.
• If you receive a call while the page
is sounding, the handset stops
beeping and starts ringing.
MEMORY DIALING
The ET-1104 can store four telephone
numbers in speed dial memory, and you
can dial these numbers by pressing a
single button. You can also store up to
20 more numbers that you can dial by
entering a two-digit memory location
number.
Storing a Number in Memory
Note:
An error tone sounds and the
phone exits the storing process if you
wait more than 30 seconds between
each key press.
1. Lift the handset.
2. Press
MEM
. The TALK/MUTE LOW
BATT indicator blinks.
3. Enter the number and any tone
mode changes or pause entries
(see “Entering a Pause” on
Page 16).
Notes:
Each number you store can be up to
16 digits long.
If you try to enter more than 16 dig-
its, the phone sounds an error tone
and exits the storing process. Start
over at Step 2.
Each tone or pause entry uses one
digit of memory.
43-1104.fm Page 15 Wednesday, August 18, 1999 8:05 AM