Filter
Top Products
11
OPERATION
MAKING AND RECEIVING
CALLS
Before you use the phone, put the head-
set on and adjust it as needed.
To make a call, lift the keypad off the
base, then press
TALK. You hear the dial
tone and the IN USE indicator lights. Dial
the number you want to call.
To answer a call, lift the keypad off the
base, then press
TALK. The IN USE indi-
cator lights.
To end a call, press
TALK or place the
keypad on the base.
Notes:
• When you press a button, a single
tone indicates that the phone has ac-
cepted the command. Three tones in-
dicate that you pressed a button in
error, you are out of range, or there is
too much interference. If there is se-
vere interference, see “Changing
Channels.”
• If interference is severe, the keypad
might lose communication with the
base and the call might disconnect. If
this happens, return the keypad to the
base for about five seconds to reset
the security access-protection code.
ADJUSTING THE
HEADSET’S VOLUME
To adjust the headset’s volume, repeat-
edly press
VOLUME ▲ or VOLUME ▼ dur-
ing a call until the sound level is
comfortable. You can set the headset’s
volume to one of eight levels, and it will
remain set even after you hang up.
CHANGING CHANNELS
Every time you press TALK, the ET-1101
automatically selects a clear channel from
the 40 it uses for communication between
the headset and the base. If you hear in-
terference during a call, repeatedly press
CHANNEL to change the channel until you
get a clear one.
TALK
VOLUME
CHANNEL
REDIAL
43-1101.fm Page 11 Friday, July 9, 1999 9:32 AM