Filter
Top Products
10
SETTING THE KEYPAD’S
RINGER VOLUME
You can adjust the keypad’s ringer vol-
ume by repeatedly pressing
RINGER AD-
JUST
when the phone is not in use. The
keypad rings with the current volume
(high, medium, or low) as you select it.
Note:
You cannot adjust the base’s ringer
volume.
SETTING THE DIALING
MODE
Set TONE-PULSE on the side of the base
for the type of service you have. If you are
not sure which type you have, do this sim-
ple test after charging the battery pack.
1. Set
TONE-PULSE to TONE.
2. Press TALK so the IN USE indicator
lights and listen for a dial tone.
3. Press any number other than
0.
Note:
If your phone system requires
that you dial an access code (9, for
example) before you dial an outside
number, do not press the access
code either.
If the dial tone stops, you have touch-
tone service. If the dial tone contin-
ues, you have pulse service.
4. If you have tone service, leave
TONE-
PULSE
set to TONE. If you have pulse
service, set
TONE-PULSE to PULSE.
5. To hang up, place the keypad on the
base or press
TALK.
RINGER
ADJUST
IN USE
Indicator
43-1101.fm Page 10 Friday, July 9, 1999 9:32 AM