Filter
Top Products
9
Installation
Note:
To mount the phone directly on a wall,
you need two screws (not supplied) with
heads that fit into the keyhole slots on the
bottom of the base.
Follow the steps under “On a Wall Plate or
Wall” on Page 8, then apply these additional
instructions.
1. Drill two holes 3
15
/
16
inches
(100 mm) apart. Then thread
a screw into each hole, let-
ting the heads extend about
3
/
16
inch (5 mm) from the
wall.
2. Plug one end of the supplied long modu-
lar cord into the
TEL
LINE
jack on the
back of the base and route the adapter
cable and modular cords through the
grooves on the bracket.
3. Align the bracket’s keyhole slots with the
mounting screws and slide the phone
downward to secure it.
CONNECTING, CHARGING,
AND REPLACING THE
BATTERY PACK
The phone comes with a rechargeable
nickel-cadmium battery pack in the hand-
set. Before using your phone, you must
connect the battery pack, then charge it for
about 24 hours.
1. Press down and slide off the battery
pack compartment cover.
2. Lift the battery pack out of the compart-
ment.
3. Plug the battery pack's connector into
the socket in the compartment, (the con-
nector fits only one way), replace the
battery pack, and replace the cover.
To charge the battery pack, place the hand-
set either faceup or facedown on the base.
The CHARGE/IN USE indicator on the base
lights and
Total:00
appears.
Recharge the battery pack when
Low
Bat-
tery
flashes.
Important:
Be sure the battery pack is prop-
erly connected before you try to charge it.
The CHARGE/IN USE indicator lights when
the handset is on the base, even if the bat-
tery pack is not connected.
Notes:
• When you first use the phone after
charging or recharging the battery pack,
the phone might not work and you might
hear a beep when you press
TALK
.
Return the handset to the base for about
5 seconds to reset the security access-
protection code.
• If the base loses power for 60 minutes
while the handset is away from it or the
handset’s battery pack is completely dis-
charged, the security access-protection
code might be lost. To reset the code,
3
15
/
16
"
3
/
16
"
43-5520.fm Page 9 Friday, July 21, 2000 8:01 AM