Filter
Top Products
18
Operation
Entering a Pause
In some telephone systems, you must dial an
access code (9, for example) and wait for a
second dial tone before you can dial an out-
side number. You can store the access code
with the phone number. However, you
should also store a pause after the access
code to allow the outside line time to con-
nect.
To enter a 2-second pause, press
PAUSE
(
RDL/PAUSE
on the handset).
P
appears if
you are storing a number into the handset’s
memory. You can add more pause entries
for a longer pause.
Reviewing the Handset’s
Memory Numbers
To review your handset’s memory numbers,
press
MEM
. The list of memory location num-
bers (
01
–
20
) appears with the name stored
with each number (or
<Memory
nn>
if you
did not store a name).
To see the stored phone numbers, press
7
77
7
.
An arrow to the right of the number means it
is longer than 13 digits. Press
7
77
7
again to
see the rest of the number. Repeatedly press
6
66
6
to return to the name display.
To exit the memory number list, press
MEM
.
To see a stored name and phone number at
the same time, press
SELECT/CHANNEL
when the cursor is by a memory location
number. To exit this display, hold down
DEL
until the display clears.
Dialing a Memory Number
To dial a number stored in the handset’s
memory, lift the handset and press
MEM
. The
list of memory location numbers appears.
Choose a memory location (01–20) by press-
ing a number or by repeatedly pressing
VOL/
CID
8
88
8
or
9
99
9
, then press
TALK
.
To dial a number stored in the base’s memo-
ry, press
SPEAKER
. When you hear a dial
tone, press
MEM
, then press the memory lo-
cation number and the phone dials the num-
ber.
Note:
If you select an empty memory loca-
tion in the base, the phone beeps five times.
Enter the correct memory location number.
Chain-Dialing Service Numbers
For quick recall of numbers for special ser-
vices (such as bank by phone), store each
group of numbers in its own memory loca-
tion. Dial the service’s main number first.
Then, at the appropriate place in the call,
press
MEM
and the number for the location
where the additional information is stored.
Testing Stored Emergency
Numbers
If you store an emergency service’s number
(police department, fire department, ambu-
lance) and you choose to test the stored
number, make the test call during the late
evening or early morning hours to avoid peak
demand periods. Also, remain on the line to
explain the reason for your call.
USING A HEADSET
You can talk with hands-free convenience
using an optional headset that has a
3
/
32
-inch
(2.5-mm) plug. Contact your local Ra-
dioShack store for a suitable headset.
To connect the headset, open the rubber
cover marked on the side of the handset,
then insert the headset’s plug into the jack.
43-5520.fm Page 18 Friday, July 21, 2000 8:01 AM