Filter
Top Products
8
Installation
• Always connect the AC adapter to the
phone before you connect it to AC
power. When you finish, disconnect the
adapter from AC power before you dis-
connect it from the phone.
Note:
Your telephone connects directly to a
modular telephone line jack. If your phone
line jack is not a modular jack, you can up-
date the wiring yourself, using jacks and
adapters available at your local RadioShack
store. Or, you can let the phone company up-
date the wiring for you.
The USOC number of the jack to be installed
is RJ11C (RJ11W for a wall plate).
On a Desk Top, Shelf, or Table
1. Plug one end of the supplied long modu-
lar cord into the
TEL
LINE
jack on the
back of the base.
2. Plug the modular cord’s other end into a
modular telephone line jack.
3. Insert the supplied AC adapter’s barrel
plug into the
DC
IN
9V
jack on the back
of the base.
4. Route the adapter’s cord through the
strain relief slot on the bottom of the
base.
5. Plug the adapter into a standard AC out-
let.
6. Lift the base’s antenna to a vertical posi-
tion.
On a Wall Plate or Wall
1. Insert the two tabs at the top of the nar-
row end of the supplied bracket into the
base’s upper tab slots, then press down
on the bracket’s latches and insert them
into the lower slots.
2. Plug one end of the supplied short mod-
ular cord into the
TEL
LINE
jack on the
back of the base.
3. Insert the supplied AC adapter’s barrel
plug into the
DC
IN
9V
jack.
4. Route the adapter and modular cords
through the grooves on the bracket.
5. Plug the modular cord’s other end into
the wall plate jack, then align the
bracket’s keyhole slots with the wall
plate studs and slide the phone down-
ward to secure it.
6. Plug the adapter into a standard AC out-
let.
7. Press and lift out the handset holder.
Rotate it 180°, then snap it back into
place so it holds the handset.
8. Lift the base’s antenna to a vertical posi-
tion.
43-5520.fm Page 8 Friday, July 21, 2000 8:01 AM