Filter
Top Products
18
Telephone Operation
:[b[j[ýC[cehodd
:[b[j[ýC[cehodd:[b[j[ýC[cehodd
:[b[j[ýC[cehodd
— the display prompts
you to confirm the deletion. Press
VOL/
CID
8
88
8
to move the cursor to
O[i
O[iO[i
O[i
, then
press
SELECT
or
DELETE/CH
. The
phone beeps, and
C[cehoddý :[b[j[Z
C[cehoddý :[b[j[ZC[cehoddý :[b[j[Z
C[cehoddý :[b[j[Z
appears.
=eý8WYa
=eý8WYa=eý8WYa
=eý8WYa
— returns you to the list of mem-
ory numbers.
5. Press
VOL/CID
8
88
8
or
9
99
9
to highlight the
desired option, then press
SELECT
.
Entering a Pause
In some telephone systems, you must dial an
access code (9, for example) and wait for a
second dial tone before you can dial an out-
side number. You can store the access code
with the phone number. However, you
should also store a pause after the access
code to allow the outside line time to con-
nect. To enter a 2-second pause, press
PAUSE
.
F
FF
F
appears on the display. You can
add more pause entries for a longer pause.
Reviewing Memory Numbers
To review your memory numbers, press
MEM
. The list of memory location numbers
(01–20) appears with the name stored with
each number (or
2C[cehodd4
2C[cehodd42C[cehodd4
2C[cehodd4
if you did not
store a name).
To see the stored phone numbers, press
FLASH/
7
77
7
. An arrow to the right of the num-
ber means it is longer than 14 digits. Press
FLASH/
7
77
7
again to see the rest of the num-
ber. Repeatedly press
REDIAL/
6
66
6
to return to
the name display.
To exit the memory number list, press
MEM
.
To see a stored name and phone number at
the same time, press
SELECT
when the cur-
sor is by a memory location number. To exit
this display, hold down
DELETE/CH
until the
display clears.
Dialing a Memory Number
To dial a number stored in memory, lift the
handset and press
MEM
. The list of memory
location numbers appears.
Choose a memory location (01–20) by press-
ing a number or by repeatedly pressing
VOL/
CID
8
88
8
or
9
99
9
, then press
TALK
.
You can also dial a memory number after
pressing
TALK
. Press
MEM
(the display does
not change but the phone’s memory recall
activates), then enter a memory location
number.
Chain-Dialing Service Numbers
For quick recall of numbers for special ser-
vices (such as bank-by-phone), store each
group of numbers in its own memory loca-
tion. Dial the service’s main number first.
Then, at the appropriate place in the call,
press
MEM
and enter the number for the lo-
cation where the additional information is
stored.
Testing Stored Emergency Num-
bers
If you store the number of an emergency ser-
vice (police department, fire department, am-
bulance) and you choose to test the stored
number, remain on the line to explain the
reason for your call. Make the test call during
the late evening or early morning hours to
avoid periods of peak demand.