Filter
Top Products
9
Installation
4. Route the adapter and modular cords
through the grooves on the bracket.
5. Plug the modu-
lar cord's other
end into the wall
plate jack, then
align the base’s
keyhole slots
with the wall
plate studs and
slide the base downward to secure it.
6. Plug the adapter into a standard AC out-
let.
7. Press and lift out the handset holder.
Rotate it 180°, then snap it back into
place so it holds the handset.
8. Lift the base's antenna to a vertical posi-
tion.
Note:
To mount the phone directly on a wall,
you need two screws at least 1
3
/
8
inch long
(not supplied) with heads that fit into the key-
hole slots on the bottom of the base.
Follow the steps under “On a Wall Plate or
Wall” on Page 8, then apply these additional
instructions for placement on a wall.
1. Drill two holes 3
15
/
16
inches (100 mm) apart.
Then thread a screw into
each hole, letting the
heads extend about
3
/
16
inch (5 mm) from the wall.
2. Plug one end of the sup-
plied long modular cord
into the
TEL LINE
jack on the back of the
base and route the adapter cable and
modular cords through the grooves on
the base.
3. Align the
base’s key-
hole slots with
the mounting
screws and
slide the base
downward to
secure it.
CONNECTING, CHARGING,
AND REPLACING THE
BATTERY PACK
The phone comes with a rechargeable
nickel-cadmium battery pack in the hand-
set. Before using your phone, you must
connect the battery pack, then charge it for
about 24 hours.
1. Press down and slide off the battery
pack compartment cover.
2. Lift the battery pack out of the compart-
ment.
3
15
/
16
"
3
/
16
"
43-5521.fm Page 9 Monday, June 5, 2000 12:29 PM