Filter
Top Products
8
Installation
Cautions:
You must use a Class 2 power
source that supplies 9V DC
and delivers at least 210 mA.
Its center tip must be set to positive and
its plug must fit the phone's
DC IN 9V
jack. The supplied adapter meets these
specifications. Using an adapter that
does not meet these specifications
could damage the phone or the adapter.
• Always connect the AC adapter to the
phone before you connect it to AC
power. When you finish, disconnect the
adapter from AC power before you dis-
connect it from the phone.
Note:
Your telephone connects directly to a
modular telephone line jack. If your tele-
phone wiring does not have a modular jack,
you can update the wiring yourself using
jacks and adapters available at your local
RadioShack store, or have the telephone
company update the wiring for you.
The USOC number of the jack to be installed
is RJ11C (or RJ11W for a wall plate jack).
On a Desk, Shelf, or Table
Follow these steps when you place the base
on a desk, shelf or table.
1. Insert the bracket’s tabs into the base’s
upper tab slots, then press down on the
bracket’s clips and insert them into the
clip slots.
2. Plug one end of the supplied long modu-
lar cord into the
TEL
LINE
jack on the
back of the base.
3. Insert the supplied AC adapter's barrel
plug into the
DC IN 9V
jack on the back of
the base.
4. Route the adapter's cord through the
strain relief slot on the bracket.
5. Plug the modular cord's other end into
the phone jack.
6. Plug the adapter into a standard AC out-
let.
7. Lift the base's antenna to a vertical posi-
tion.
On a Wall Plate or Wall
1. Insert the bracket’s tabs into the base’s
lower tab slots, then press down on the
bracket’s clips and insert them into the
clip slots.
2. Plug one end of the supplied short mod-
ular cord into the
TEL LINE
jack on the
back of the base.
3. Insert the supplied AC adapter's barrel
plug into
DC IN 9V
jack.
!
TEL LINE
DC IN 9V Jack
43-5521.fm Page 8 Monday, June 5, 2000 12:29 PM