Filter
Top Products
21
Memory Dialing
ˆ
Memory Dialing
You can store up to 30 numbers in the hand-
set’s memory and another 10 in the base’s
memory, then dial a stored number by press-
ing a memory location number. You can also
store a name with each number in the hand-
set’s memory.
Each number you store can be up to 20 dig-
its long, and each name can be up to 13
characters.
You cannot dial a number stored in one
memory location (the base or the handset)
using the keypad on the other.
STORING A NUMBER IN
MEMORY
Note:
The phone beeps five times and exits
the storing process if you wait more than 20
seconds between each key press.
In the Handset
1. Lift the handset.
2. Hold down
MEM
until
C[ceho
C[cehoC[ceho
C[ceho
Ijeh[
Ijeh[Ijeh[
Ijeh[
and a
list of memory location numbers (and
names, if any) appears.
3. Select an empty memory location (or the
one you want to replace) by entering the
location number (
01
–
30
) or using
8
88
8
/
INTCM
or
CONF
/
9
99
9
to scroll through the
list. Precede a single digit number with a
0
(for example,
01
,
02
,
03
, and so on.).
Note:
If the phone sounds five quick
beeps, you have made an entry error
and the number was not stored. Reenter
the location number correctly.
4. Press
SELECT/CH
.
Ijeh[
Ijeh[Ijeh[
Ijeh[
DWc[
DWc[DWc[
DWc[
appears.
If you do not want to enter a name, skip
to Step 6.
5. To enter a name, use the number keys.
Refer to the letters on the number keys
to select the desired letter. Press the key
once for the first letter in the upper case,
press twice for the second letter in the
upper case, and so on. To enter the
lower case letter, press four times (or
five times) to display the first letter in
lower case, five or six times for the sec-
ond letter, and so on.
For example, to enter John: press
5
once; upper case
@
@@
@
appears. Then press
6
six times; lower case
e
ee
e
appears. Press
4
five times; lower case
^
^^
^
appears.
Finally, press
6
five times; lower case
d
dd
d
appears.
To enter two letters from the same key in
a row, press
#
/
7
77
7
to move the cursor to
the next position. For example to enter
AB, press
2
;
7
77
7
appears. Then press
#
/
7
77
7
, the cursor moves to the next posi-
tion, then press
2
twice so
8
88
8
appears.
To enter a space, press
#
/
7
77
7
twice with-
out entering any character.
To enter a number, repeatedly press the
corresponding number key until the
number appears.
To enter a special character, use
0
. Each
time you press
0
, the following charac-
ters appear in this order:
∗
∗∗
∗
#
–
&
( )
(space)
&
&&
&
If you make a mistake, use
∗
∗∗
∗
/
TONE
/
6
66
6
or
#
/
7
77
7
to move the cursor over the
error, then enter the correct character, or
press
DEL
/
VOL
to delete a character. To
delete all characters, hold down
DEL
/
VOL
for at least 1 second.