Filter
Top Products
13
Installation
• If the handset’s display is blank and the
phone does not work, recharge the bat-
tery pack. (The battery power might be
too low to light the display.)
• If the battery pack becomes weak during
a call, the handset beeps every 3 sec-
onds and
Bem
BemBem
Bem
8Wjj[ho
8Wjj[ho8Wjj[ho
8Wjj[ho
flashes. When this
happens, you cannot make another call
on the phone until you recharge the bat-
tery pack.
• About once a month, fully discharge the
battery pack by keeping the handset off
the base until
Be m
Be mBe m
Be m
8Wjj[ho
8Wjj[ho8Wjj[ho
8Wjj[ho
flashes. Other-
wise, the battery pack loses its ability to
fully recharge.
• If the battery pack is completely dis-
charged or the base loses power while
the handset is away from it, place the
handset on the base to reset the secu-
rity access-protection code. If the hand-
set loses power, recharge the battery
pack.
The supplied battery pack should last about
one year. If the battery pack does not hold a
charge for more than 2 hours after an over-
night charge, replace it with a new 3.6-volt,
600 mAh battery pack with a connector that
fits the socket in the battery compartment.
You can order a replacement battery pack
through your local RadioShack store.
Note:
To avoid losing memory numbers, in-
stall and begin charging the new battery
pack within 2 minutes.
Warning:
Dispose of the old battery pack
promptly and properly. Do not burn or bury it
(see “Battery Safety Instructions” on Page 5
for additional information on proper battery
handling).
If you have trouble replacing the battery, take
the phone to your local RadioShack store for
assistance.
Important:
The EPA certified
RBRC
®
Battery Recycling Seal
on the nickel-cadmium (Ni-Cd)
battery indicates RadioShack
is voluntarily participating in an
industry program to collect and recycle these
batteries at the end of their useful life, when
taken out of service in the United States or
Canada. The RBRC program provides a
convenient alternative to placing used Ni-Cd
batteries into the trash or the municipal
waste stream, which may be illegal in your
area. Please call 1-800-THE-SHACK (1-
800-843-7422) for information on Ni-Cd bat-
tery recycling and disposal bans/restrictions
in your area. RadioShack’s involvement in
this program is part of the company’s com-
mitment to preserving our environment and
conserving our natural resources.
SETTING THE DIALING
MODE
Your phone comes set for tone dialing. If you
have pulse service, you need to change the
dialing mode. If you are not sure which type
of service you have, do this test.
Press
LINE
1
on the base. The LINE 1
SPEAKER indicator lights. Listen for a dial
tone, then press any number other than
0
.
Note:
If your phone system requires that you
dial an access code (9, for example) before
you dial an outside number, do not press the
access code either.
If the dial tone stops, you have touch-tone
service. If the dial tone continues, you have
pulse service.
To set the dial mode, press
LINE
1
to hang
up the phone if necessary, then hold down
FLASH
on the base until the phone beeps.
Then press
#
/
7
77
7
on the base to set to pulse
mode or
∗
∗∗
∗
/
TONE
/
6
66
6
on the base to set to
tone mode. The phone beeps.