Filter
Top Products
Installation
8
the back of the phone. Route the cord
through the strain-relief slot on the
base.
Ô
2. Plug the supplied AC adapter’s barrel
plug into the
DC IN 9V
jack on the back
of the base and route the adapter’s
cord through the strain relief slot on the
bottom of the base.
3. Plug the adapter into a standard AC
outlet.
4. Connect the phone cord(s) to the
modular phone line jack(s).
5. Raise the base’s antenna to a vertical
position.
On a Wall Plate
1. Connect the phone line(s) as described
in “On a Desk Top”. Use the shorter
modular cord to mount the phone on
the wall plate.
2. Insert the supplied AC adapter’s barrel
plug into the
DC IN 9V
jack on the back
of the base.
3. Route the adapter’s cord through the
narrow groove on the base. If you are
using two phone cords, route the
second cord through one of the wide
grooves on the base.
4. Plug the other end of the short modular
cord into the wall plate jack, then align
the keyhole slots with the wall plate
studs and slide the base downward to
secure it. If you are using two phone
cords, plug the second cord into the
second phone jack.
Ô NOTE Ô
To connect the phone to a
single one-line phone jack,
plug one end of the
supplied long modular cord
into the TEL LINE 1/2 or
TEL LINE 2 jack. Route the
cord through the strain-
relief slot on the base.
43-3701.fm Page 8 Thursday, April 24, 2003 11:56 AM