Filter
Top Products
Powering the Radio
9
2. To use the supplied dual charger,
connect the supplied AC-DC
adapter to the jack on the back of
the dual charger. Then plug the
other end into an AC socket. Ô
3. Pull down the latch on the battery
compartment cover, then remove
the cover.
4. Set
CHARGE ON/OFF to ON.
5. Place four Ni-CD or Ni-MH
batteries in the radio’s battery
compartment according to the
polarity symbols (
+ and –) marked
inside, then replace the cover and
push the latch up until it clicks.
6. To use an optional AC or DC
adapter, attach the Adaptaplug to
the adapter so
TIP reads positive
(
+). Then connect the Adaptaplug’s
other end to the radio’s
DC 6V jack.
Then plug the adapter into a
standard AC outlet or vehicle’s
power source.
Otherwise, to use the supplied
dual charger, simply place the
radios in the charger. Ô
7. When charging is complete,
remove the radios from the dual
charger or unplug the AC or DC
Ô NOTE Ô
• The charger might
not supply enough
currenttochargethe
batteries if you use
the radio to transmit
at the same time.
• To ensure proper
charging, use a
pencil eraser to clean
thecontactsonthe
bottom of the radio
and inside the dual
charger.
CAUTION
You must use a Class 2
power source that
supplies regulated 6V
DC (Not more than 6V)
and delivers at least
600mA. Its center tip
must be set to positive
and its plug must fit the
radio’s DC 6V jack.
Using an adapter that
does not meet these
specifications could
damage the radio or the
adapter.