Filter
Top Products
35 Beyond the Basics
using signal stalker
To turn on Signal Stalker, press FUNC + once
except in WX search, band select, or program
mode. appears. Every two seconds, the
scanner searches for frequencies in the range you
specified in “setting the signal stalker options” on
Page 32.
Note: To continue scanning normally while Signal
Stalker works, simply press SCAN.
When the scanner finds a frequency, it sounds the
alert you specified in “setting the signal stalker
options” on Page 32, and “Found” flashes. Press any
key to confirm the displayed frequency. Press SCAN
to resume scanning. Or press or while the
frequency and appear to select the band where
you are searching.
To turn on Signal Stalker and turn off normal scan-
ning, press FUNC + twice. flashes. To turn
off Signal Stalker and turn on normal scanning,
press FUNC + three times. disappears.
F