Filter
Top Products
SERMC Contact: Tad Hunt (402) 219-7378 thunt@stez.org SKC Contact: (800) 882-7779 contact.us@skccom.com 7
Setting Up the VSX 7000
Equipment Placement
• Place the VSX 7000 codec on the monitor, or a shelf directly above the monitor. The front lip should
overlap the front of the monitor.
• Place the subwoofer near the codec. The subwoofer should not be placed in a closed cabinet or cart.
• Center the mic pod(s) on the table, at least 3’ from the system, with at least 6’ between each mic pod.
Connecting the Cables
1. Connect the VSX to the monitor with the yellow S-Video cable and/or Red/White/Yellow composite cables.
2. If you have purchased a dual monitor cable, connect it to the VSX 7000, then connect each monitor.
3. If using a second camera or document camera, connect its S-video cable to the Camera 2 input (top input).
4. If using a VCR/DVD, connect its red/white/yellow composite audio/video cable to the top RCA in/outputs.
5. Connect any RS-232 peripherals, such as a Crestron control panel, to the RS-232 port, if applicable.
6. Connect the brown mic pod cable to the VSX 7000 and the mic pod. If you purchased a People + Content
Visual Concert VSX, connect it to the mic port, then connect the mic(s) to the Visual Concert VSX.
7. Connect the black LAN cord to the orange LAN port on the VSX 7000 and your local network connection.
8. If using the Quad BRI ISDN or V.35 serial interface, connect the cables to the network.
9. Connect the subwoofer cable to the light blue port. Connect the ISDN module, if applicable, by removing
the plate on the back of the subwoofer.
10. Verify the power switch on the back of the VSX 7000 is turned to OFF (O), then connect the power cord to
the subwoofer and plug into a power outlet. Put 3-AAA batteries in the remote.
Note: Your system administrator or SKC installation technician will configure the settings for your VSX 7000.
For further configuration assistance, please reference the Administrator’s Guide or contact SKC.