Filter
Top Products
SoundStation IP 3000 Installation Instructions and User’s Guide
2
Caution: Be sure to read the Release
Notes (online at www.polycom.com)
and both the Parts List and the Safety
Notices sections in this guide before
you set up and use this product.
Installing SoundStation IP 3000
Preparing for Installation
To install the SoundStation IP and connect
it to the network, complete the following
steps.
1 Place the SoundStation IP on a flat
surface (such as a conference room table
or desktop), with a power outlet and a
data network port nearby.
2 Connect one end of the 6 ft. data cable
to your data network port.
Connect the other end to the network
(LAN) port on the PIM.
3 Connect the 25 ft. data cable to
the RJ-45 port on the bottom of the
SoundStation IP. (The other end of this
cable is pre-plugged into the PIM.)
4 Connect the power adapter to the AC
adapter port on the PIM.
5 Plug the other end into a standard
electrical power outlet in the wall.
Installing and Connecting to the Network
When you have finished connecting the
phone, a start-up process will automatical-
ly begin. During this process, which may
last several minutes, the LCD will display
a sequence of screens. When the process
is complete, and your SoundStation IP
is ready for use, you will hear a tone
indicating that the unit has been initialized.
The LCD will appear as shown:
If you are installing the SoundStation IP
yourself, first:
Verify that your system administrator
has prepared the network and IP
telephony infrastructure for the
SoundStation IP 3000.
Data
Network
Port
AC Power
PIM
AC Adapter
2
3
4
5
Bottom of IP 3000
RJ-45 Port
Startup Sequence