Filter
Top Products
3. Charging
During normal operation, it takes approximately 3 1/2 hours to charge the handset from fully discharged to its full
capacity. Place the handset in the charger. When the handset is turned on, the display shows the charging status in
line 3. For correct charging be sure the room temperature is between 0°C and 25°C. Do not place the handset in di -
rect sunlight. The battery has a built-in heat sensor which will stop charging if the battery temperature is too high.
It is necessary to recharge the battery when the display shows “BATTERY LOW”, or if it can not be turned on. The
LED flashes at a low frequency while charging and lights constantly when the charging is finished. The display
goes back to normal mode when fully charged.
When the handset is placed in the charger it will not vibrate, and B-answer is inactive. If the battery is fully dis -
char ged, up to 10 min. may pass before charging begins and the handset can be turned on. When the charger
begins the charging, status is shown in the 3rd line of the display and the LED flashes slowly.
6
KIRK telecom
❚❚❚❚❚❚❚❚❚ . . . .
1408 8700-ed9:1408 8700-ed9.qxd 03-10-2008 11:11 Side 6