Filter
Top Products
PN: 1725-36143-001_K.doc
5
Plan the Interface
The system administrator programs the telephone system for use with
the SpectraLink 8000 System using the normal administration
terminal or procedures. Programming can be done after the handsets
are registered.
Recommended programming includes assigning extension numbers
to the handsets and programming features on the telephone system so
they are easily accessible from the handsets.
For analog interfaces, macro codes are in the document relating to
configuring the system. See SpectraLink 8000 Telephony Gateway:
Administration Guide for SRP.
The following information will help the system administrator set up
the SpectraLink e340/h340/i640 Wireless Telephones to operate in a
way that feels familiar and comfortable to users.
Plan Programming
Digital Interface programming for the SpectraLink e340/h340/i640
Wireless Telephones will be faster if it is planned in advance by
verifying the parameters and features on the current telephone
system and wired phones. The system administrator must assign
extension numbers to the handsets and plan the functions (trunk
access, toll restrictions, system features, ringing options etc.) to be
programmed for the handsets.
It may also help to identify a key layout that is programmed exactly
or close to the way the handsets should be programmed, and use the
programming for that set as a model for programming the handsets.
Line appearances
The handsets support two line appearances for the Hicom 150/
HiPath 3000 and four line appearances for the Hicom 300/HiPath
4000. Determine what extension numbers will be assigned to the
1