Filter
Top Products
PN: 1725-36143-001_K.doc
15
Interface Implementation
This section describes the recommended programming to use the
SpectraLink 8000 Telephony Gateway with the Siemens Hicom 150/
HiPath 3000 E and 300 E/H Communications Server (CS). The
procedures assume:
• The Siemens Hicom CS system is installed and initialized.
• A trained Siemens technician or system administrator will be on
site with the Installer to program the system.
Set the Switch Interface Type
Connect to the SpectraLink 8000 Telephony Gateway using the serial
or modem interface. From the Main Menu, choose Gateway
Configuration. Scroll to Telephone Switch Type and press enter to
change this field, from the Submenu of PBX types, select Hicom 150/
HiPath 3000 or 300. Refer to the SpectraLink 8000 Telephony Gateway:
Administration Guide for SRP document for details on configuring the
Telephone Switch.
Programming the Softkeys on the Handset to Emulate optiset E
Functionality
The following table illustrates how the softkeys on the handset may
be programmed so that they conform to the default emulation
described in the diagrams on the next pages. Programming the
softkeys will override the default programming. Softkeys and
shortcut sequences may be programmed to additional features as
well. See the corresponding table and instructions in the section on
programming the softkeys and shortcut keys in the SpectraLink 8000
Telephony Gateway: Administration Guide for SRP document.
2