Filter
Top Products
10
11
en
Indicator Lights and Tones
Light Tone
Incoming call 3 blue flashes every 2 seconds 3 rapid low tones
every 2 seconds
Answer call 1 blue flash 1 low tone
Call in progress 1 blue flash every 2 seconds None
Volume up or
down
1 blue flash for each volume
adjustment
1 tone with volume
corresponding to
volume level
2 low tones to
indicate maximum
volume level
reached
End call 1 blue flash 1 low tone
Missed call 3 purple flashes every 10
seconds for 5 minutes
None
Out of range None 1 high tone
Back in range Flashes to match current
earpiece state
1 low tone
Turning on
multipoint
2 blue flashes None
Turning off
multipoint
1 blue flash None
NOTE By default, the online indicator is turned on. To turn off the online
indicator, see “Earpiece Controls” on page 8.
Troubleshooting
My earpiece
does not work
with my phone.
Make sure the earpiece is fully charged.
Make sure earpiece is paired with the Bluetooth
phone you are trying to use.
See “Pairing Your Earpiece” on page 4.
My phone did not
locate the earpiece.
Turn both your phone and earpiece off and on,
and then repeat the pairing process on page 4.
I could not enter
my PIN code.
Turn both your phone and earpiece off and on,
and then repeat the pairing process on page 4.
Your PIN code, or Passkey, is 0000.
I cannot hear
caller/dial tone.
The earpiece is not turned on. Press the call
control button for approximately 2 seconds until
you hear a tone or see the indicator glow blue.
Your earpiece is out of range. Move the earpiece
closer to the Bluetooth phone.
Your earpiece battery is drained. Charge your
battery. See “Charging Your Earpiece” on page 1.
The listening volume is too low. Incremental
tapping of the volume button will adjust volume.
See instructions for adjusting the volume in
“Earpiece Controls” on page 8.
Make sure that the eartip fits properly. See
“Adjusting the Fit” on page 6.