Filter
Top Products
6
7
en
How to Install a Different Gel Eartip
If the earpiece does not feel stable, the eartip needs adjusting or it may
be the wrong size for your ear. The earpiece comes with the medium
eartip installed, but you can replace it with the optional small or large
eartip provided.
Adjusting the Fit
For optimal voice clarity,
point the boom towards
the corner of your mouth.
Correct Fit Incorrect Fit
2 3
1 Remove the earpiece from your ear.
Rotate the eartip on the earpiece to position the stabilizer to rest
comfortably in your ear. If the earpiece still feels unstable, then remove
the ear-piece from your ear and change the eartip to a different size.
2 To remove the eartip, gently pull the stabilizer loop of eartip
off of the speaker housing.
3 To fit a new eartip, position the eartip over the speaker
housing with the stabilizer pointed away from the microphone
boom and gently press the eartip onto speaker housing.
Eartip
Speaker housing
1
Earpiece Controls
Turn on the earpiece Press and hold the call control button for 2
seconds until the indicator glows blue. If earpiece
flashes red 3 times when you turn on the earpiece
then the battery is very low and should be
recharged.
NOTE When your earpiece is in standby mode, the indicator
is off. To confirm that your earpiece is on, press any button.
You should see a blue light flash.
Turn off the earpiece Press and hold the call control button for 4
seconds until the indicator glows red. When
power is off, indicator stays off.
NOTE If you’re wearing the earpiece, you hear ascending
tones when the power turns on and descending tones when
the power turns off.
Answer or reject
a call
When your earpiece rings, tap the power button
once; you should hear 1 low tone.
To reject a call and send the caller to voice mail,
press the call control button for 2 seconds.
NOTE Your phone may ring before your earpiece rings.
Wait until you hear the ring in your earpiece to press the call
control button and answer the call.
End a call During active call, tap the call control button.
Make a call When the earpiece is paired to your phone and in
range, enter phone number on your phone and
press send. The call automatically transfers to
your earpiece.
Transfer a call
between earpiece
and phone
During an active call, press and hold the call
control button for 2 seconds. You will hear a
single low tone followed by a double low tone.