Filter
Top Products
25
Appendix
(1) this device may not cause harmful
interference; and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to
comply with the limits for a Class b digital device,
pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable
protection against harmful interference in a
residential installation.
This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no guarantee
that interference will not occur in a particular
installation.
If this equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna
(that is, the antenna for radio or television that
is “receiving” the interference).
• Reorient or relocate and increase the
separation between the telecommunications
equipment and receiving antenna.
• Connect the telecommunications equipment
into an outlet on a circuit different from that to
which the receiving antenna is connected.
If these measures do not eliminate the
interference, please consult your dealer or an
experienced radio/television technician for
additional suggestions. Also, the Federal
Communications Commission has prepared a
helpful booklet, “How To Identify and Resolve
Radio/TV Interference Problems”. This booklet is
available from the U.S. Government Printing
Office, Washington, D.C. 20402.
Please specify stock number 004-000-00345-4
when ordering copies.
11.6 Noise
Electrical pulse noise is present at one time or
another. This is most intense during electrical
storms. Certain kinds of electrical equipment,
such as light dimmers, fluorescent bulbs, motors,
fans, etc., also generate pulse noise. Because radio
frequencies are susceptible to this, you may on
occasion hear pulse noise through the receiver.
This is usually only a minor annoyance and should
not be interpreted as a defect of the unit.
11.7 FCC RF Radiation Exposure
Statement
This equipment complies with FCC RF radiation
exposure limits set forth for an uncontrolled
environment. This equipment should be installed
and operated with a minimum distance of
20 centimeters between the radiator and your
body. This transmitter must not be co-located or
operating in conjunction with any other antenna
or transmitter.
For hand held operation, this phone has been
tested and meets the FCC RF exposure
guidelines. For Body-worn operation, use only
with the belt clip. Use of other accessories may
not ensure compliance with FCC RF exposure
guidelines.
11.8 Hearing Aid Compatibility (HAC)
This telephone system meets FCC and Industry
Canada standards for Hearing Aid Compatibility.
11.9 Privacy
Privacy of communications may not be ensured
when using this telephone.
11.10 Additional Information
I.C. Notice