Filter
Top Products
8900-A2-GB20-30 June 2004 3-1
3
Configuration Using the Web Interface
Overview
This chapter provides instructions on how to configure the ATM line cards using
the SCP card’s web interface.
Configuring Spectrum Management
Use the Configuration - DSL General screen to enable and disable Spectrum
Management. When Spectrum Management is enabled, the maximum transmit
speeds and maximum transmit power are limited to meet local spectrum
management guidelines.
Procedure
To enable or disable Spectrum Management:
1. Select Disable or Enable from the drop-down list.
2. For the 8985 line card, additionally select the Spectrum Management Region:
— ANSI T1417 – To select American National Standards Institute T1.417
definitions
— ANFP ND 1602 – To select Access Network Frequency Plan ND1602
definitions
3. Click on Apply.
If you would like to configure the
card using . . . See the . . .
The BAC’s TL1 Interface (when an
SCP card with an ATM uplink is used)
8620 and 8820 Broadband Access
Concentrator TL1 Interface Reference
The BAC’s router-like command line
interface (when an SCP card with an IP
uplink is used)
8620 and 8820 Broadband Access
Concentrator Command Line Interface
Reference
GrandVIEW EMS 4.1 or above GrandVIEW EMS User’s Guide
SNMP using another EMS 8620 and 8820 Broadband Access
Concentrator SNMP Reference