Filter
Top Products
Doorphone
20
If it is diffi cult to hear the visitor’s voice due to noise (Press-to-talk mode)
You can speak with the visitor alternately by pressing {TALK} to switch between the talking mode and the
receiving mode. (You can operate this feature in the same way by using either the main monitor station or the
sub monitor station.)
1 Press and hold {TALK} for about 2 seconds during a call until a beep sounds.
L appears on the main monitor station.
appears on the sub monitor station.
2 To speak to the visitor:
Speak while pressing and holding {TALK}.
To hear the visitor:
Release {TALK}.
Note:
LPress-to-talk mode is canceled after the conversation ends.
Using {DOOR KEY} button
When a separate door opener is connected to the main monitor station, you can open the door using the main
monitor station or the sub monitor station.
1 To open the door, press {DOOR KEY} after answering a call from the door station or while monitoring images
taken by the door station.
LWhen the door is opened,
is displayed
.
LDoor opener allows you to open the door for the time specifi ed in “Setting {DOOR KEY} button” on page
35.
Note:
LYou cannot open the door while receiving a call from the door station.
LWhen using 2 door openers:
You can open door 1 (door opener 1) when you are talking with door station 1 or monitoring it. You can open
door 2 (door opener 2) when you are talking with door station 2 or monitoring it.