Filter
Top Products
48
Remote Operation from a Touch Tone Phone
You can operate the Answering System from any touch tone phone.
A synthesized voice menu will guide you through the Answering System (p. 49).
• To skip the voice menu and operate the unit directly, see page 50.
Summary of remote operation
Remote Code
The remote code prevents unauthorized people from accessing your unit and
listening to your messages. Choose any
2-digit number (00–99)
for your remote
code.
The factory preset remote code is “
11
”. If you do not program your own remote
code, you can use “11”.
To check the remote code,
repeat steps 1 to 4.
• The remote code is displayed. When finished, press
[OFF]
.
Call your unit from a touch tone phone.
• The unit will announce the
remaining recording time
after playback, if it is less
than 3 minutes.
• The messages are saved.
Enter your remote code (see below) during or
after the greeting message.
• The number of new messages is heard.
After 3 seconds, the voice menu will start
(p. 49).
Follow the menu or enter the direct commands
(p. 50).
To end remote operation, hang up.
1
Press
[MENU]
.
2
Scroll to “
Initial setting
” by pressing
[]
or
[]
, then press
Select
.
3
Scroll to “
Set answering
” by pressing
[]
or
[]
, then press
Select
.
4
Scroll to “
Remote code
” by pressing
[]
or
[]
, then press
Select
.
5
Enter a
2-digit remote code (00–99)
.
6
Press
Save
, then press
[OFF]
.
Handset
>
>
Initial setting
Exit Select
>
>
>
>
Set answering
Back Select
>
>
>
>
Remote code
Back Select
>
>
Remote code
:11
Back Save