Filter
Top Products
75
Useful Information
For assistance, please call: 1-800-211-PANA(7262)
Problem
“No link to base
Place on cradle and
try again.” is displayed
and an alarm tone sounds.
Static, sound cuts in/out,
fades. Interference from
other electrical units.
The unit does not ring.
The handset display is
blank.
You cannot store a name
and phone number in the
directory.
While programming or
searching, the unit starts to
ring and stops the program/
search.
You cannot make a call with
the handset.
Remedy
•You are too far from the base unit. Move
closer and try again.
•Place the handset on the base unit and
try again.
•Plug in the AC adaptor.
•Raise the base unit antenna.
•Locate the handset and the base unit
away from other electrical appliances
(p. 3).
•Move closer to the base unit.
•Raise the base unit antenna.
•Press Ü to select a clearer channel in
the talk, speakerphone, intercom or
remote operation mode.
•The ringer volume is set to OFF. Set to
HIGH or LOW (p. 20).
•Charge the battery fully (p. 14).
•You cannot store an item in the directory
while the unit is in the talk, speaker or
intercom mode or while the answering
system is in use.
•Do not pause for over 60 seconds while
storing.
•To answer the call, press or .
Start again from the beginning after
hanging up.
•You cannot make a call when the unit is
in the remote operation mode. Exit the
mode by pressing (OFF) (p. 68).
Cordless Telephone
Troubleshooting