Filter
Top Products
Feature Operations
Making Calls
This section explains the basic methods for making a
call.
Making a Call
1. In stand-by mode, go off-hook.
2. Enter the number you want to call.
3. Press [ENTER], or wait a few seconds for the
number to be dialed.
4. To end the call, go on-hook.
Pre-dialing
In stand-by mode, you can start dialing (max. 32 digits)
while still on-hook.
• To delete a number you entered, press .
• To clear the entire number, press and hold
.
• To connect the call, go off-hook or press [ENTER].
Note
• For KX-UT133/KX-UT136, you can also press
an idle DN button (flexible button) to connect the
call. For details about DN buttons, see "Flexible
Buttons (KX-UT133/KX-UT136 only)
(Page 34)".
• If you receive an incoming call during
pre-dialing, the display changes to the incoming
call screen. For KX-UT133/KX-UT136, you can
close the incoming call screen by pressing
, and continue pre-dialing.
Making a Call from the
Phonebook List
Scrolling through all entries
1. Press .
2. Press [ ] or [ ] to select an entry.
3. Go off-hook.
4. To end the call, go on-hook.
Note
• For KX-UT133/KX-UT136, you can also press
an idle DN button (flexible button) in step 3 to
connect the call. For details about DN buttons,
see "Flexible Buttons (KX-UT133/KX-UT136
only) (Page 34)".
• For KX-UT113/KX-UT123, you can press
instead of going off-hook. If more than
one line is available at your unit, select the line
to use, and then press [ENTER].
• In step 2, if multiple phone numbers are stored
for the entry, you can press and then
select the phone number to call.
Searching by name
1. Press .
2. Press .
3. Enter the name (max. 12 characters) you want to
search for.
4. Press [ENTER].
The entry that matches your search appears.
5. Go off-hook.
6. To end the call, go on-hook.
Note
• For KX-UT113/KX-UT123, you can press
instead of going off-hook. If more than
one line is available at your unit, select the line
to use, and then press [ENTER].
• For details about entering characters, see
"Entering Characters (Page 47)".
• In step 4, if multiple phone numbers are stored
for the entry, you can press
and then
select the phone number to call.
• If you do not press any buttons for 1 minute, the
unit will return to stand-by mode.
Dialing by Using Call Logs
The last 30 incoming calls and outgoing calls are stored
in their respective logs, in order of newest to oldest call.
You can make calls to the numbers listed in the call logs.
1. Press
.
2. Press [
] or [ ] to select the call log type, and then
press [ENTER].
3. Press [ ] or [ ] to select the desired entry.
4. Go off-hook.
5. To end the call, go on-hook.
Note
• For KX-UT133/KX-UT136, you can also press
an idle DN button (flexible button) in step 4 to
connect the call. For details about flexible
buttons, see "Flexible Buttons (KX-UT133/
KX-UT136 only) (Page 34)".
Document Version 2011-06 Operating Instructions 25
Feature Operations