Filter
Top Products
Useful Information
42
Programmable settings
Battery recharge
I cannot use the
intercom or
phonebook copy
feature.
L These features are shared between the handsets.
Although the handset displays “Intercom”, “Copy
All”, or “Copy”, these features are not available for
this model.
Problem Cause/solution
The display is in a
language I cannot
read.
L Change the display language (page 12).
While programming,
the display returns to
standby mode.
L A call matching an entry in the call barred list is being
received. Wait and try again later.
I cannot activate the
eco mode.
L You cannot set eco mode when you set the repeater
mode “On”. If required, set the repeater mode to
“Off” (page 30).
I cannot register a
handset to a base unit.
L The maximum number of base units (4) is already
registered to the handset. Cancel unused base unit
registrations from the handset (page 30).
L The maximum number of handsets (6) is already
registered to the base unit. Cancel unused handset
registrations from the base unit (page 30).
L You entered the wrong PIN. If you forget your PIN,
contact an authorised service centre.
Problem Cause/solution
The handset beeps
and/or ) flashes.
L Battery charge is low. Fully charge the batteries (page
8).
I fully charged the
batteries, but
– ) still flashes or
– the operating time
seems to be shorter.
L Clean the battery ends (S, T) and the charge
contacts with a dry cloth and charge again.
L It is time to replace the batteries (page 8).
The handset display is
blank.
L The handset is not turned on. Turn the power on (page
12).
Problem Cause/solution
TG8511_19BX(e).book Page 42 Thursday, July 8, 2010 5:44 PM