Filter
Top Products
SMS (Short Message Service)
35
Reading a received message
1
1 (centre of navigator key) i
X i M
2 {V}/{^}: “Receive List” i M
3 {V}/{^}: Select a message.
L Messages which have already
been read are indicated by a “Q”.
L To erase a message, press W.
i {V}/{^}: “Yes” i M
4 Press M to read the message
content.
Note:
L To call the message sender, press
{C}.
Replying to a message
1
While reading a received message,
press 1.
2 {V}/{^}: “Reply” i M
3 Enter a message (page 37). i
M
4 Edit the destination phone number if
necessary. i M
5 Continue from step 5, “Writing and
sending a new message”, page 33.
Editing/forwarding a message
1
While reading a received message,
press 1.
2 {V}/{^}: “Edit Message” i M
3 Continue from step 3, “Writing and
sending a new message”, page 33.
Erasing received messages
1
While reading a received message,
press 1.
2 {V}/{^}: “Erase” i M
L To erase all messages, select
“Erase All”. i M
3 {V}/{^}: “Yes” i M i {ic}
Storing the sender’s number
in the phonebook
1
While reading a received message,
press 1.
2 {V}/{^}: “Add Phonebook” i
M
3 To store the name, continue from
step 2, “Adding entries”, page 18.
Editing the sender’s number
before calling back
1
While reading a received message,
press 1.
2 {V}/{^}: “Edit & Call” i M
3 Edit the number. i {C}
Other settings
Storing the PBX line access
number (for PBX users only)
Store your PBX line access number (4
digits max.) so that SMS messages are
sent properly. When sending SMS
messages to entries in the phonebook or
redial list, the PBX line access number is
deleted. The default setting is “Off”.
1 1 (centre of navigator key) i
{#}{3}{5}{6}
2 {V}/{^}: “On” i M
3 Enter your PBX line access code
and a dialling pause, if necessary.
i M i {ic}
TG8511_19BX(e).book Page 35 Thursday, July 8, 2010 5:44 PM