Filter
Top Products
Programming
29
2 Enter the base unit PIN (default:
“0000”).
L If you forget your PIN, contact an
authorised service centre.
3 t
L Handset registered to the base
unit is displayed.
L “Q” is displayed next to the
handset number.
L To cancel the handset, press t
again. “Q” disappears.
4 M
5 {V}/{^}: Select a memory location.
i M
6 Enter the phone number or area
code to be restricted (8 digits max.).
i M i {ic}
L To erase a restricted number,
press ^.
Note:
L You can also select a memory location
in step 5 as follows:
Press {1} to {6}. i M
Registering a unit
Operating additional units
Additional base units
Handsets can be registered to up to 4
base units, allowing you to add
additional base units and extend the
area in which your handset(s) can be
used. If a handset moves out of range of
its base unit when “Auto” is selected on
base unit (page 29), it looks for another
base unit to make or receive calls. A
base unit and the handsets it
communicates with is called a “radio
cell”.
Note:
L Calls are disconnected when the
handset moves from one radio cell to
another.
Registering a handset to a
base unit
The supplied handset and base unit are
pre-registered. If for some reason the
handset is not registered to the base unit
(for example, _ is displayed even when
the handset is near the base unit), re-
register the handset.
1 Handset:
1 (centre of navigator key) i
{#}{1}{3}{0}
2 {V}/{^}: Select a base unit number.
i M
L This number is used by the
handset as a reference only.
3 Base unit:
Press and hold {x} for about 5
seconds. (No registration tone)
L If all registered handsets start
ringing, press the same button to
stop. Then repeat this step.
L The next step must be completed
within 90 seconds.
4 Handset:
Wait until “Base PIN” is displayed.
i Enter the base unit PIN (default:
“0000”). i M
L If you forget your PIN, contact an
authorised service centre.
L When the handset has been
registered successfully, w is
displayed.
Selecting a base unit
When “Auto” is selected, the handset
automatically uses any available base
unit it is registered to. When a specific
base unit is selected, the handset makes
and receives calls using that base unit
TG8511_19BX(e).book Page 29 Thursday, July 8, 2010 5:44 PM