Filter
Top Products
Problem Cause/solution
Caller information is not
announced.
R The handset or base unit’s ringer volume is turned
off. Adjust it (page 31, 33).
R When one handset is selected to ring for cellular
calls, other units do not announce caller
information. To change the selection, see page 17.
R The Talking Caller ID feature is turned off. Turn it
on (page 33).
R The ring as cell mode is set to “On (without
Talking CID)”. To change the mode, see
page 17.
R Depending on the number of rings setting, the
answering system may answer calls before
announcing the caller information. Select a
different setting (page 51).
R Your unit does not announce caller information if
– 2 or more handsets are on a call.
– a headset is in use.
Time on the unit has
shifted.
R Incorrect time information from incoming Caller ID
changes the time. Set the time adjustment to
“Manual” (off) (page 32).
Using Bluetooth devices
Problem Cause/solution
I cannot copy phonebook
entries from a cellular
phone.
R Confirm that the cellular phone supports Bluetooth
wireless technology.
R Confirm that the cellular phone supports the
Phone Book Access Profile (PBAP) or Object
Push Profile (OPP) specification.
R If the cellular phone is already connected to
another Bluetooth device such as a Bluetooth
headset, turn it off or disconnect it from the cellular
phone.
R Someone is using a cellular line or headset. Try
again later.
R Turn the cellular phone off, then turn it on and try
again.
R If an entry is already stored in the unit’s shared
phonebook, the entry cannot be copied even by
selecting another group.
I cannot have a
conversation using the
headset.
R Your Bluetooth headset is not registered. Register
it (page 45).
R Turn your headset off, then turn it on and try again.
66
Useful Information
TG76xxAZ(en)_0207_ver012.pdf 66 2012/02/07 15:34:49