Filter
Top Products
Error messages
Display message Cause/solution
Base no power
or
No link. Re-connect base
AC adaptor.
or
No link.
R The handset has lost communication with the base
unit. Move closer to the base unit and try again.
R Unplug the base unit’s AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R The handset’s registration may have been canceled.
Re-register the handset (page 35).
R When “No link.” is displayed during a power
failure, place a handset on the base unit to supply
power to the base unit.
Busy
R The called unit is in use.
R Other units are in use and the system is busy. Try
again later.
R The handset you are using is too far from the base
unit. Move closer and try again.
Call phone company for
your access #
R You have not stored the voice mail access number.
Store the number (page 47).
Check tel line
R The supplied telephone line cord has not been
connected yet or not connected properly. Check the
connections (page 10).
Error!!
R Recording was too short. Try again.
Invalid
R There is no handset registered to the base unit
matching the handset number you entered.
R The handset is not registered to the base unit.
Register the handset (page 35).
Requires subscription to
Caller ID.
R You must subscribe to a Caller ID service. Once you
receive caller information after subscribing to a Caller
ID service, this message will not be displayed.
Use rechargeable battery.
R A wrong type of battery such as Alkaline or
Manganese was inserted. Use only the rechargeable
Ni-MH batteries noted on page 5, 7.
52
For assistance, please visit http://www.panasonic.com/help
Useful Information
TG684x7x(en)_1127_ver021.pdf 52 2012/11/27 18:16:49