Filter
Top Products
Sub-menu 1 Sub-menu 2 Settings Code
Caller ID edit
(Caller ID number auto
edit)
– <On> Off #214 38
Change language
(Display)
– <English>
Español
#110 14
Main menu: “Cust. Support”
Operation Code
Displaying customer support Web address. #680 –
*1 If you program these settings using one of the units, you do not need to program the same
item using another unit.
*2 This menu is not displayed when scrolling through the display menus. It is only available in
direct command code.
*3 This feature allows the unit to automatically adjust the date and time each time caller
information including date and time is received.
To turn this feature on, select “Caller ID auto”. To turn this feature off, select
“Manual”. (Caller ID subscribers only)
To use this feature, set the date and time first (page 14).
*4 If you subscribe to a distinctive ring service (such as IDENTA-RING), select a tone (tone 1 to
3). If you select a melody, you cannot distinguish lines by their ringers.
*5 If you select one of the melody ringer tones, it will continue to play for several seconds even
if the caller has already hung up. You may either hear a dial tone or no one on the line when
you answer the call.
*6 The preset melodies in this product are used with permission of © 2009 Copyrights Vision
Inc.
*7 Turn this feature off if you prefer not to hear key tones while you are dialing or pressing any
keys, including confirmation tones and error tones.
*8 If you subscribe to a Caller ID service and want to view the caller’s information after lifting up
the handset to answer a call, turn off this feature.
*9 The flash time depends on your telephone exchange or host PBX. Contact your PBX
supplier if necessary. The setting should stay at “700 ms” unless pressing MFLASHN fails to
pick up the waiting call.
*10 Generally, the line mode setting should not be changed. This setting automatically maintains
receiver volume at the proper level depending on the current telephone line condition. Set
the line mode to “A” if telephone line condition is not good.
*11 This setting is available when you have the key detector (KX-TGA20). Read the installation
guide for more information on the key detector.
*12 For models with supplied key detectors, the display shows “1: Detector1”.
*13 If you register 2 or more key detectors.
*14 If you have 2 or more key detectors.
For assistance, please visit http://www.panasonic.com/help
31
Programming
TG684x7x(en)_1127_ver021.pdf 31 2012/11/27 18:16:47