Filter
Top Products
Error messages
Display message Cause/solution
Base no power
o
r
N
o link. Reconnect
AC adaptor.
or
No link.
R The handset has lost communication with the base unit. Move
closer to the base unit and try again.
R Unplug the base unit’s AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R The handset’s registration may have been cancelled.
Re-register the handset (page 49).
R When “No link.” is displayed during a power failure, place
a handset on the base unit to supply power to the base unit.
Check Phone Line
R The supplied telephone line cord has not been connected yet
or
not connected properly. Check the connections (page 9).
Error
R Recording was too short. Try again.
Fa
iled
R Phonebook copy failed (page 21). Confirm the other handset
(t
he receiver) is in standby mode and try again.
Incomplete
R The receiver’s phonebook memory is full. Erase the unwanted
ph
onebook entries from the other handset (the receiver) and
try again.
Memory Full
R The phonebook memory is full. Erase unwanted entries
(p
age 20).
R Message memory is full. Erase unwanted messages
(page 35, 36).
R The call barred list memory is full. Erase unwanted entries
(page 30).
Use rechargeable
bat
tery.
R A wrong type of battery such as Alkaline or Manganese was
inserted. Use only the rechargeable Ni-MH batteries noted on
page 5, 7.
You must first
sub
scribe to Caller
ID.
R You must subscribe to a Caller ID service. Once you receive
caller information after subscribing to a Caller ID service, this
message will not be displayed.
45
Useful Information
TG68xxBX_UE(en)_0523_ver021.pdf 45 2013/05/23 16:41:17