Filter
Top Products
Advanced new message
ale
rting features
Audible message alert
Thi
s feature allows the base unit to beep to
inform you of a new message arrival when
new messages are recorded. The base unit
beeps 2 times every minute until you listen to
the messages, if the “Base Unit Beep”
setting is turned on. The default setting is
“Off”.
1 M
N#339
2 MbN: S
elect the desired setting. a MOKN
a MeN
New message alert by a call
Thi
s feature allows the unit to make a call to
the pre-stored phone number and inform you
that a new message has been received by
announcement.
To use this feature, you must:
– store a phone number to which the unit
makes the call to.
– turn on the new message alert setting.
After you answer the new message alert call,
you can listen to messages from that call
(page 38).
Important:
R A new message alert is stopped 1 minute
after the unit starts to call. The unit will not
retry the call even if the call is not answered.
Storing a phone number to which the
unit makes an alert call
n From the phonebook:
1 M N#338
2 MbN: “No
tification to” a MOKN
a M
N
3 MbN: “Phonebook” a MOKN
4 MbN: Select the desired phonebook
entry. a MOKN a MeN
n By entering a phone number:
1 M
N#338
2 MbN:
“N
o
tification to” a MOKN
a M
N
3 MbN: “Ma
nual” a MOKN
4 Enter the desired name (16 characters
max.; page 43). a MOKN
5 Enter the desired number (24 digits
max.). a MOKN 2 times a MeN
Turning on/off the new message alert
setting
1 M N#338
2 MbN: “On
/Off” a MOKN
3 MbN: Select the desired setting. a MOKN
a MeN
Editing the set phone number
1 M
N#338
2 MbN: “No
tification to” a MOKN
3 M
N a MbN:
“E
d
it” a MOKN
4 Edit the name if necessary (16 characters
max.; page 43). a MOKN
5 Edit the phone number if necessary (24
digits max.). a MOKN 2 times a MeN
Erasing the set phone number
1 M N#338
2 MbN: “No
tification to” a MOKN
3 M
N a MbN: “Er
ase” a MOKN
4 MbN: “Yes” a MOKN a MeN
R The new message alert setting is
turned off.
Activating/inactivating the remote
acc
ess code to play messages
If you activate this feature, you must enter the
remote access code (page 38) to play the
new message from the new message alert
call. This is so that unauthorised parties
cannot listen to your messages. The default
setting is “Inactivate”.
37
Answering System
TG68xxBX_UE(en)_0523_ver021.pdf 37 2013/05/23 16:41:17