Filter
Top Products
Arabic/Persian: Month/Date
Eng
lish: Date/Month
R Press M
N to stop the alarm completely.
R When the handset is in use, the alarm will
not sound until the handset is in standby
mode.
R Press any dial key, M
N,
or M
N
to stop
t
h
e sound but keep the snooze function
activated.
R If you want to make an outside call when
the snooze function is activated, please
stop the snooze function before making the
call.
Night mode
Nig
ht mode allows you to select a period of
time during which the handset will not ring for
outside calls. This feature is useful for time
periods when you do not want to be disturbed,
for example, while sleeping. Night mode can
be set for each handset.
Important:
R Set the date and time beforehand
(page 14).
R We recommend turning the base unit ringer
off (page 25) in addition to turning the night
mode on. (KX-TG6821 series: page 3)
R If you have set the alarm, the alarm sounds
even if the night mode is turned on.
Turning night mode on/off
1 M N#238
2 MbN: S
elect the desired setting. a MOKN
R If you select “Off”, press MeN to
exit.
3 Enter the desired hour and minute you
wish to start this feature. a MOKN
4 Enter the desired hour and minute you
wish to end this feature. a MOKN
5 MeN
R When the night mode is set,
is
dis
played.
Changing the start and end time
1 M N#237
2 Continue from step 3, “Turning night
mo
de on/off”, page 29.
Setting the ring delay
Thi
s setting allows the handset to ring during
night mode if the caller waits long enough.
After the selected amount of time passes, the
handset rings. If you select “No Ringing”,
the handset never rings during night mode.
1 M
N#239
2 MbN: S
elect the desired setting. a MOKN
a MeN
Note:
R When the answering system answers the
call, this feature does not work.
(KX-TG6821 series: page 3)
Changing the handset name
Eac
h handset can be given a customised
name (“Bob”, “Kitchen”, etc.). This is useful
when you make intercom calls between
handsets. You can also select whether or not
the handset name is displayed in standby
mode. The default setting is “No”. If you select
“Yes” without entering any handset name,
“Handset 1” to “Handset 2” is displayed.
1 M
N#104
2 Ent
er the desired name (max. 10
characters; page 43).
R If not required, go to step 3.
3 MOKN
4 MbN: Select the desired setting. a MOKN
2 times
5 MeN
Incoming call barring (Caller ID
sub
scribers only)
This feature allows the unit to reject calls from
specified phone numbers that you do not want
to answer such as junk calls.
When a call is received, the unit does not ring
while the caller is being identified. If the phone
number matches an entry in the call barred
list, the unit emits no sound to the caller, and
disconnects the call.
29
Programming
TG68xxBX_UE(en)_0523_ver021.pdf 29 2013/05/23 16:41:16