Filter
Top Products
Programming
29
(for example, _ is displayed even when
the handset is near the base unit), re-
register the handset.
1 Handset:
8 i {#}{1}{3}{0}
2 Base unit:
Press and hold {x} for about 5
seconds, until the registration tone
sounds.
L If all registered handsets start
ringing, press the same button to
stop. Then repeat this step.
L The next step must be completed
within 90 seconds.
3 Handset:
Wait until “Base PIN” is displayed.
i Enter the base unit PIN (default:
“0000”). i M
L If you forget your PIN, contact an
authorised service centre.
L When the handset has been
registered successfully, w is
displayed.
Deregistering a handset
A handset can cancel its own
registration that is stored to the base
unit. This allows the handset to end its
wireless connection with the system.
1 8 i {#}{1}{3}{1}
2 {V}/{^}: Select the handset you
want to cancel. i M
3 {V}/{^}: “Yes” i M
L A confirmation tone sounds.
L The handset does not beep when
cancelling its own registration.
4 {ic }
Increasing the range of the
base unit
You can increase the signal range of the
base unit by using a DECT repeater.
Please use only the Panasonic DECT
repeater noted on page 4. Contact your
Panasonic dealer for details.
Important:
L Before registering the repeater to this
base unit, you must turn the repeater
mode on.
L Do not use more than one repeater at
a time.
Setting the repeater mode
1 8 i {#}{1}{3}{8}
2 {V}/{^}: Select the desired setting.
i M i {ic}
Note:
L After turning the repeater mode on or
off, _ is displayed on the handset
momentarily. This is normal and the
handset can be used once w is
displayed.
TG6551-6561BX(e).book Page 29 Friday, July 23, 2010 10:06 AM