Filter
Top Products
Programmable Settings
40
Programming via direct commands
You can also programme most features using “direct commands”—special codes that take
you directly to the feature you wish to programme and allow you to select the desired
setting. There is no need to scroll through the unit’s menus.
Details of each feature can be found on the corresponding pages.
1 Press {MENU}.
2 Enter the desired feature code (shown below).
3 Enter the desired setting code (shown below).
LThis step may vary depending on the feature being programmed.
4 Press {Save}.
5 Press {OFF} to exit programming mode.
Direct commands chart
Feature Feature code Setting code Page
Ringer volume {1} {1}{1}: Low {2}: Medium
{3}: High {0}: Off
page 34
Ringer tone {1} {2}{1}–{3}: Tone pattern 1–3
{4}–{7}: Melody pattern 1–4
page 35
Interrupt tone {1} {3}{1}: On {2}: 2 times {0}: Off page 35
Message play {2} – page 45
Date and time {4} Go to step 3 on page 17. page 17
Voice enhancer {5}{1}: On {0}: Off page 36
Dial lock {6} Go to step 3 on page 38. page 38
LCD contrast {0} {1}{1}–{6}: Level 1–6 page 36
Key tone {0} {2}{1}: On {0}: Off page 38
Auto talk {0} {3}{1}: On {0}: Off page 36
Set area code {0} {4} Go to step 4 on page 37. page 37
Set dial mode {0} {5} {1} – page 58
Set recall time {0} {5} {2}{1}: 700 ms {2}: 600 ms
{3}: 400 ms {4}: 300 ms
{5}: 250 ms {6}: 110 ms
{7}: 100 ms {8}: 90 ms
page 37
Set line mode {0} {5} {3}{1}: A {2}: B page 37
Ring count {0} {6} {1}{2}–{7}: 2–7 rings
{0}: Toll saver
page 49
TG5838_5839AL.book Page 40 Tuesday, March 15, 2005 9:30 PM