Filter
Top Products
Programmable Settings
33
Programming via direct commands
You can also programme most features using “direct commands”—special codes that take
you directly to the feature you wish to programme and allow you to select the desired
setting. There is no need to scroll through the unit’s menus.
Details of each feature can be found on the corresponding pages.
1 Press {MENU}.
2 Enter the desired feature code (shown below).
3 Enter the desired setting code (shown below).
L This step may vary depending on the feature being programmed.
4 Press {Save}.
5 Press {OFF} to exit programming mode.
Direct commands chart
Note:
L If you make a mistake or enter the wrong code, press {OFF} then start again by
pressing {MENU}.
Feature Feature code Setting code Page
Ringer volume {1}{1}{1}: Low {2}: Medium
{3}: High {0}: Off
page 28
Ringer tone {1}{2}{1}–{3}: Tone pattern 1–3
{4}–{7}: Melody pattern 1–4
page 28
Voice enhancer {5}{1}: On {0}: Off page 29
Dial lock {6} Go to step 3 on page 31. page 31
LCD contrast {0}{1}{1}–{6}: Level 1–6 page 29
Key tone {0}{2}{1}: On {0}: Off page 31
Auto talk {0}{3}{1}: On {0}: Off page 29
Set area code
{0}{4} Go to step 4 on page 30 page 30
Set dial mode {0}{5}{1} – page 38
Set recall time {0}{5}{2}{1}: 700 ms {2}: 600 ms
{3}: 400 ms {4}: 300 ms
{5}: 250 ms {6}: 110 ms
{7}: 100 ms {8}: 90 ms
page 30
Set line mode {0}{5}{3}{1}: A {2}: B page 30
Handset registration {0}{0} Go to step 4 on page 32. page 31