Panasonic KX-TG2336 Telephone User Manual


 
Voice Mail Service
For assistance, please call: 1-800-211-PANA(7262)
43
Advanced Operation
Setting Voice Mail (VM) Tone Detection
Your telephone company sends special signals (Voice mail tones) to the unit.
Press [C], [s] or [SP-PHONE] to listen to the dial tone. If you hear a series of dial
tones followed by a continuous dial tone, this indicates that a new message was
recorded. Voice Mail detection is preset at the factory to ON. Minutes after you
hang up or after the phone stops ringing, your unit will seize the phone line and
check if a message has been recorded. If a new message was recorded at your
telephone company, “Voice Mail” will be displayed on the handset, the
Ringer/Message Alert indicator on the handset will flash slowly if Message Alert is
turned on (p. 18), and the VM indicator on the base unit will flash.
Turn off this programming when:
—you do not subscribe to a voice mail service,
—your telephone company does not send a series of tones, followed by a
continuous tone to indicate you have new voice mail, or
—your phone is connected to a business or office telephone system (PBX).
See below to turn this setting off.
If you are not sure which setting is required, consult your local telephone company
or contact the Panasonic Customer Call Center.
1 Press [MENU].
2 Scroll to “Initial setting” by pressing [
d
]
or [
B
], then press Select.
3 Press Select at “Voice Mail”.
4 Scroll to “VM tone detect” by pressing [
d
]
or [
B
], then press Select.
5 Select “Off” or “On” by pressing [
d
] or [
B
].
6 Press Save, then press [OFF].
Handset
Initial setting
Back Select
K
d
BL
Voice Mail
Back Select
K
d
BL
VM tone detect
Back Select
K
d
BL
VM tone detect
:On
Back Save
K
d
BL
PQQX13986YA.book 43 ページ 2004年1月22日 木曜日 午後5時40分