Filter
Top Products
Using the Caller List
Basic Operation
For assistance, please call: 1-800-211-PANA(7262)
29
Caller ID Number Auto Edit
Once you call back an edited number (p. 28), this unit can automatically edit
incoming phone numbers from the same area code in the Caller List and each time
you receive a call. For example, it can ignore the area code of calls originating from
your area code, so that you can call these numbers from the Caller List without
dialing the area code.
To activate this feature, you must edit a caller’s phone number in the Caller List
(p. 28) by selecting pattern F, G, or H, then make a call to that number. Calls
from numbers in that area code will be edited automatically. The unit can remember
up to 4 area codes to be edited according to patterns F and G.
When more than 5 area codes are edited, older area codes are reset to pattern H.
Phone numbers from the 4 most recently edited area codes will be automatically
edited.
You can turn this feature on or off using the handset. The factory preset is ON.
To turn Caller ID Number Auto Edit on or off
• If you fail to reach your destination when making a call, the phone number you
dialed might have an incorrect pattern. Edit the phone number with another
pattern (p. 28).
• When this feature is turned off, the unit will still be able to display Caller ID, but
incoming Caller ID numbers will not be automatically edited.
• If you move to another area, you may need to turn this feature off to erase the
previously edited area codes. To use this feature again, turn it on and reprogram
the area codes you want to edit once again.
1 Press [MENU].
2 Scroll to “Initial setting” by pressing [
d
]
or [
B
], then press Select.
3 Scroll to “Caller ID edit” by pressing [
d
]
or [
B
], then press Select.
4 Select “Off” or “On” by pressing [
d
] or [
B
].
5 Press Save, then press [OFF].
Handset
Initial setting
Back Select
K
d
BL
Caller ID edit
Back Select
K
d
BL
Auto edit
:On
Back Save
K
d
BL
PQQX13986YA.book 29 ページ ２００４年１月２２日 木曜日 午後５時４０分