Panasonic KXTG1062M Answering Machine User Manual


 
Answering System
35
For assistance, please visit http://www.panasonic.com/help
*1 If pressed within the first 5 seconds of a
message, the previous message is played.
*2 For English voice guidance only:
To resume operation, enter a remote command
within 3 seconds, or the voice guidance starts.
*3 For Spanish voice guidance only
*4 Unit resets to a pre-recorded greeting message.
Turning on the answering system
remotely
If the answering system is off, you can turn it on
remotely.
1 Dial your phone number from a touch-tone
phone.
2 Let the phone ring 15 times.
L A long beep is heard.
3 Enter your remote access code within 10
seconds after the long beep.
L The greeting message is played back.
L You can either hang up, or enter your
remote access code again and begin
remote operation (page 34).
Answering system settings
Number of rings before the unit
answers a call
You can change the number of times the phone
rings Ring count before the unit answers
calls. You can select 2 to 7 rings, or Toll
saver.
The default setting is 4.
Toll saver: The unit’s answering system
answers at the end of the 2nd ring when new
messages have been recorded, or at the end of the
4th ring when there are no new messages. If you
call your phone from outside to listen to new
messages (page 34), you know that there are no
new messages when the phone rings for the 3rd
time. You can then hang up without being charged
for the call.
1 {MENU} i {#}{2}{1}{1}
2 {V}/{^}: Select the desired setting. i
{SAVE} i {OFF}
For voice mail service subscribers
If you subscribe to a flat-rate service package that
includes Caller ID, call waiting, voice mail, and
unlimited local/regional/long distance calls, please
note the following:
L To use the voice mail service provided by your
service provider/telephone company rather than
the unit’s answering system, turn off the
answering system (page 31).
L To use this unit’s answering system rather than
the voice mail service provided by your service
provider/telephone company, please contact
your service provider/telephone company to
deactivate your voice mail service.
If your service provider/telephone company
cannot do this:
Set this unit’s Ring count setting so that
this unit’s answering system answers calls
before the voice mail service of your service
provider/telephone company does. It is
necessary to check the number of rings
required to activate the voice mail service
provided by your service provider/telephone
company before changing this setting.
Change the number of rings of the voice mail
service so that the answering system can
answer the call first. To do so, contact your
service provider/telephone company.
Caller’s recording time
You can change the maximum message recording
time allotted to each caller. You can also select
Greeting only which sets the unit to greet
callers but not record messages. The default
setting is 3min.
1 {MENU} i {#}{3}{0}{5}
2 {V}/{^}: Select the desired setting. i
{SAVE} i {OFF}
Note:
L When you select Greeting only:
If you do not record your own message, the
unit will play the pre-recorded greeting-only
message asking callers to call again later.
If you use your own message, record the
greeting-only message asking callers to call
again later (page 31).
Y Handset
Y Handset
TG106x(e).book Page 35 Friday, January 16, 2009 10:45 AM