Filter
Top Products
Before Initial Use
6 Document Version 2008-01
Charger Wall Mounting
Attaching the Belt Clip and Belt Clip Holder
You can attach the handset to your belt by following the steps below.
Charger Wall Mounting
1. Install the two included screws in the wall, spacing them 28 mm (1-1/8
in) apart.
2. Mount the charger securely on the wall.
• Make sure that the wall that the charger will be attached to is strong enough to sup-
port the weight of the handset and charger (270 g [0.6 lb]). If not, it is necessary for
the wall to be reinforced.
• When this product is no longer in use, make sure to detach it from the wall.
Attaching the Belt Clip and Belt Clip Holder
28 mm
(1-1/8 in)
for charger
Washer
Drive the screw
to this point.
28 mm
(1-1/8 in)
Screws
[To attach]
Allows phone straps and similar objects to be connected.
Slide the clip into the holder until it clicks.
[To remove]
Make sure to turn the handset 180° when you
take it off.
Remove the belt clip.