Filter
Top Products
58
Base Unit Settings
Call Options
To exit the operation, press at any time.
Selecting the Flash/Earth Mode
An earth relay can be installed as an option depending on your PBX requirements.
Please consult our Panasonic Customer Care Helpline for installation. On installation,
you can then select the flash or earth mode to suit your PBX or network provider.
• The factory preset is “Flash”.
• “Type 1”: 700 ms, “Type 2”: 80 ms, “Type 3”: 400 ms. The factory preset is “Type
2”.
Selecting the Pause Time
You can select the pause time to 3 or 5 seconds, depending on your PBX requirements.
• The factory preset is “Short”.
1
Press JOYSTICK
(or move).
2
Select “ Setting
Base”.
3
Enter 4-digit Base
Unit PIN.
(Factory Preset 0000)
4
Select “Call Option”.
Go to step 5.
Follow steps 1 to 4 shown above, then:
5
Select “Recall”.
6
Select “Flash” or “Earth”.
When “Flash” was selected;
7
Select desired flash type. (see below)
Follow steps 1 to 4 shown above, then:
5
Select “Pause Time”.
6
Select “Short” (3 sec.) or “Long” (5 sec.).
515E_E.book Page 58 Friday, June 27, 2003 2:23 PM