Filter
Top Products
52
Multi-Unit User Operations
Handset Registration to a Base Unit
The handset supplied with the base unit is already registered. If an optional handset is
purchased, it must be registered as follows.
Charge the optional handset batteries for 7 hours before initial use.
Handset registration must be completed within 1 minute after pressing . If
over 1 minute, press then start over again.
To exit the operation, press at any time.
• If you enter the incorrect Base Unit PIN, the error tone sounds and repeat from step 1.
• The handset main menu may change corresponding to the base unit registered to.
1
Press JOYSTICK
(or move).
2
Select “ Setting
Handset”.
3
Select
“Registration”.
4
Select “Register
H/set”.
5
Press and hold on the Base Unit (for about 3
seconds) until the tone sounds.
•
If all registered handset(s) start ringing (paging), press
to stop paging then start over again.
6
Select the desired
base unit.
7
Enter 4-digit Base Unit
PIN.
(Factory Preset 0000)
8
Press JOYSTICK.
When a handset is registered successfully, a confirmation tone sounds and the “ ”
icon is displayed.
510AL_e.book Page 52 Monday, June 30, 2003 6:28 PM