Filter
Top Products
49
Advanced Operation
1
Press (FUNCTION/EDIT).
2
Press Ö or Ñ repeatedly until the arrow
points to “Program”.
3
Press á (Yes key).
4
Press Ö or Ñ repeatedly until the arrow
points to “Set recall”.
5
Press á (Yes key).
6
Press Ö or Ñ repeatedly until the
desired time is displayed.
7
Press á (Save key).
•A beep sounds.
•To return to the standby mode, press (EXIT/CH).
•You can exit the programming mode any time by pressing (EXIT/CH).
•Users in Australia can access Telstra’s “EASY CALL” service by having the recall
time set at 100 msec (this is the factory default setting), and then follow Telstra’s
“EASY CALL” instructions to operate this service.
•If you are connected via a PBX, a longer recall time may be necessary to use
PBX functions (transferring a call etc.). Consult your PBX supplier for the correct
setting.
LCD contrast
H
Set recall
GF H
=Yes
H
Program
GF H
=Yes
For Call Waiting Service Users in New Zealand
Make sure the recall time is set to 600 msec for use with Telecom’s
Call Waiting Service. Press (RECALL) if you hear a call-waiting tone while
talking.
•The first call is put on hold and you can answer the second call.
•To return to the first caller, press (RECALL) again.
•Your telephone company may not support the second caller display feature.
Selecting the recall time
The recall time depends on your telephone exchange or host PBX.
You can select the following recall times: “700, 600, 400, 300, 250, 110,
100 or 90 msec (milliseconds)”. KX-TC1220ALW comes from the factory
set to “100 msec” and KX-TC1220NZW comes from the factory set to
“600 msec”. Make sure the unit is in the standby mode initially.