Filter
Top Products
4.1 Troubleshooting
84 Installation Manual
4.1.5 System Reset with System Data Clear
When the PBX does not operate correctly after restarting, you can clear the programming data stored
in the PBX. The PBX will restart with the default settings.
1. Make sure that all outside (CO) lines you use are connected to the PBX.
2. Slide the System Clear Switch to the "CLR" position.
3. Press the Reset Button, and then return the System Clear Switch to the "NOR" position before
the power indicator stops flashing. (The power indicator will flash for about 5 seconds.)
CAUTION
Before touching the System Clear Switch and Reset Button, put on a grounding strap.
Notes
• After pressing the Reset Button, make sure to return the System Clear Switch to the "NOR"
position before the power indicator stops flashing, otherwise the system data will not be
cleared.
• The recorded OGMs for DISA and Built-in Voice Message are not cleared by the System
Data Clear.
Programming Manual References
[999] System Data Clear
8.3 System Reset
8.4 System Data Clear
System Clear Switch
Reset Button
NOR/CLRRESET