Filter
Top Products
Useful Information
43
For assistance, please call: 1-800-211-PANA(7262)
Troubleshooting
Problem Cause & Remedy
The unit does not work. • Check the settings (p. 8–10).
• Check whether the dialing mode setting is
correct (p. 13).
• Charge the battery fully (p. 9).
• Clean the charge contacts and charge again
(p. 10).
• Install the battery properly (p. 9).
• Place the handset on the base unit and unplug
the AC adaptor to reset it. Plug in, and try again.
• Re-install the battery (p. 9) and charge it fully.
“
No link to base.
Place on cradle and
try again.
” is displayed
and an alarm tone sounds.
• You are too far from the base unit. Walk closer
and try again.
• Place the handset on the base unit and try
again.
• Plug in the AC adaptor.
• Raise the base unit antenna.
Static, sound cuts in/out,
fades. Interference from
other electrical units.
• Move the handset and the base unit away from
other electrical appliances (p. 3).
• Walk closer to the base unit.
• Raise the base unit antenna.
• Select a clearer channel (p. 19).
The handset does not ring. • The ringer volume is set to OFF. Set to HIGH,
MEDIUM or LOW (p. 16).
The handset display is
blank.
• Charge the battery fully (p. 9).
You cannot program
function items.
• Programming is not possible while the unit is
being used.
• Do not pause for over 60 seconds while
programming.
• Walk closer to the base unit.
While programming or
searching, the unit starts to
ring and stops the
program/search.
• A call is coming in. To answer the call, press
[]
or
[]
. Start again from the beginning after
hanging up.