Filter
Top Products
Voice Mail Service
Advanced Operation
33
For assistance, please call: 1-800-211-PANA(7262)
Setting Voice Mail (VM) Tone Detection
Your telephone company sends special signals (Voice mail tones) to activate the
VM indicator.
Press
[]
or
[]
to listen to the dial tone. If you hear a pulsating tone followed by
a continuous dial tone, this is an indication that a new message was recorded.
Your phone comes set to detect these tones (set to ON). After you hang up or the
phone stops ringing, your unit will seize the phone line and check if a message has
been recorded. If a new message was recorded at your telephone company,
“
Voice Mail
” will be displayed on the handset and the VM indicator on the base
unit will flash.
Set this programming to OFF when:
—you do not subscribe to a voice mail service,
—your telephone company does not send a pulsating tone, followed by a
continuous dial tone, or
—your unit is connected to a business or office telephone system (PBX).
If you are not sure which setting is required, consult your local telephone company
or contact the Panasonic Customer Call Center.
1
Press
[MENU]
.
2
Scroll to “
Initial setting
” by pressing
[]
or
[]
, then press
Select
.
3
Scroll to “
Voice Mail
” by pressing
[]
or
[]
, then press
Select
.
4
Scroll to “
VM tone detect
” by pressing
[]
or
[]
, then press
Select
.
5
Select “
Off
” or “
On
” by pressing
[]
or
[]
.
6
Press
Save
, then press
[OFF]
.
>
>
Initial setting
Exit Select
>
>
>
>
Voice Mail
Back Select
>
>
>
>
VM tone detect
Back Select
>
>
>
>
VM tone detect
:On
Back Save
>
>