Filter
Top Products
9
Basic steps to install
1. Connect the output plug of the mains adapter to the adapter socket
on the back of the base unit and the mains adapter to the wall mains
supply.
2. Connect the telephone lead to the phone cord socket on the back of
the base unit and to the wall phone socket.
3. Remove the battery door on the handset by lifting the battery door
outward from the bottom.
4. Insert 2 x AAA rechargeable batteries supplied into each, observing
their polarities, into the battery compartment.
5. Replace the battery door firmly into place.
6. Place the handset on the base unit and let the batteries charge for a
full 14 hours before using.
Use only the mains adapter supplied with this telephone. Incorrect
adaptor polarity or voltage can seriously damage the unit.
Input: 230 VAC 50 Hz
Output: 9VDC 500 mA
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN
INCORRECT TYPE. Refer to the original type supplied with this
telephone. Ni-MH batteries must be disposed of in accordance with
applicable waste disposal regulations.
Charging the handset
An empty battery icon
indicates the batteries need recharging. Place
the handset on the base cradle to recharge the batteries. You should
hear a parking tone (double beep) when handset is put on the charging
cradle. The handset battery icon
scrolls during charging. Handset may
take some time to power up and it may get warm during initial charge.
This is normal. A handset reaching a very low battery voltage level will go
into sleep mode, displaying LOW BATT on the screen.
Tip! It is good practice to put the handset on the base unit to charge
when it is not in use or every evening to ensure the handset is always
fully charged